Connecting To Your Video Cassette Recorder; Inserting Batteries In The Remote Control - Topfield TF 5400 PVR Combo User Manual

Digital satellite & terrestrial receiver

Hide thumbs Also See for TF 5400 PVR Combo:

Table of Contents

16 Setup

2.4.3 Connecting to your video cassette recorder

The digital receiver also can output video to another appliance

such as video cassette recorder or video receiver through an

auxiliary SCART connector.

To insert the batteries, open the battery compartment by re-

moving the lid, and then insert the batteries observing the po-

larity, which is marked on the base of the battery compart-

ment.

If the digital receiver no longer reacts properly to remote con-

trol commands, the batteries may be ﬂat. Be sure to remove

used batteries. The manufacturer accepts no liability for dam-

age resulting from leaking batteries.

NOTE

In this case, you will need to connect a ca-

ble from the RF OUT socket to the antenna

connector on your television. To ensure your

television can also pick up existing analogue

channels as well, you will need to connect a

cable from your television antenna or from

the RF LOOP OUT connector on the back of

the digital receiver to RF IN connector.

You should prepare a SCART cable to use the

auxiliary SCART connector. Plug one end of

the cable into the VCR socket on the digital

receiver, and the other end into the match-

ing socket on your video cassette recorder or

suchlike.

Table of Contents