Waeco MSH-45 Installation And Operating Instructions Manual page 19

manual msh-45 14.10.2003
10. Electrical connection
Find a suitable place where to install the switch of your seat
heating. Use existing blind caps wherever possible. Make
sure there is enough space for fitting the switch behind the
covering.
Mark the cut-out for the switch using the template enclosed
in the delivery kit. Recess the marked section with a suitable
tool.
Lay the prefabricated cable loom in such a way that the cables
won't get bent or wear through (see picture 11). When laying
the cables, pay special attention to the area where the seat rails
are. For connecting the wires, see circuit diagram.
black
8:14 Uhr Seite 19
Montage
orange
+12 Volt Ignition (15)
+12 Volt permanent (30)
red
Ground (31)
10
approx. 20 mm
11
12
9