Waeco MSH-45 Installation And Operating Instructions Manual page 18

manual msh-45 14.10.2003
6. You can now insert the seat heating element in the space
between the cover fabric and the seating foam core. There
is a special slit in the foam core for additional fastening of
the cover fabric (see picture 6). In order to bridge the slit or
the cross struts, respectively, the seat heating element fea-
tures a gap. Depending on the type of the seat, this section
can be lead through the slits (see picture 7). You may as well
cut into the cross struts and put it there.
Fix the heating elements to the foam core with double-sided
adhesive tape to prevent them from slipping away. Make sure
that there are no folds or bends.
Attention! Should it become necessary to make cuts into the heating element,
mind the heating wire. The wire must not be damaged, and extreme bending
must be avoided.
7. When fitting the heating element to the backrest proceed just the same way as you did
with the seating.
8. The backrest cover can be opened in the lower section (see
picture 8).
9. Insert the heating element in the space between the seat
cover and the seat upholstery and fix it with double-sided
adhesive tape, avoiding folds. It's sufficient if the heating
surface goes approx. 30 to 35 cm beyond the seating
because the driver would normally lean against exactly that
area. In vehicles with side airbags on the seats, you will find
predetermined breaking points in the cover fabric. If that's
the case, don't stretch the seat cover too much, and make
sure that it remains in its place.
8
8:14 Uhr Seite 18
Installation of the seat heating
6
7
8
9