Programming Cv/Notes Per Step - Malekko VARIGATE 4+ Manual

VARIGATE 4+ MANUAL V.1

PROGRAMMING CV/NOTES PER STEP

CV/NOTE PROGRAMMING:
Select CHANNEL button #1.
The NOTE button will be illuminated indicating
you're ready to start programming unquantized or
quantized CV per step. Unquantized CV is useful for
animating other modules and quantized for notes
within a scale (patched to a module with a 1v/oct or
"pitch" input for instance). All CV that is
programmed within a sequence will be set to
unquantized by default and until you set the SCALE
for that channel.
Adjust sliders to the right to program CV per each
step. You can program up 5 volts per step. The LED
bar graph indicates relative value of CV per step.
One fully lit bar is approximately 1/8 of the 5V CV
range of that channel. A fully lit (slider all the way
right) bargraph represents the full 5V range of that
channel, an empty bargraph indicates 0V.
To quantize CV you've just programmed, select
TRACK and then move the slider for SCALE. You'll
notice that the LED bargraph now indicates different
scale settings. See pg. 8 for the available scales. Now
each step will be quantized cv/notes within the scale
you've selected.
Once you have CV programmed, you can add
GLIDE to a step (a smooth transition between each
step). Simply move sliders to the right to add GLIDE
per step.
Now repeat the above for CHANNEL #3.
If you want to just program CV on all 4 channels,
switch to 4 CV outs.
OCTAVE RESTRICT MODE: Once quantized CV is
programmed on a step, you can fine tune it by using
OCTAVE RESTRICT MODE (you must already be in
quantized mode first). Now hold the NOTE button
while moving the slider to program that note within
the current octave (there are 5 octaves available).
PG. 7