Programming Gates Per Step - Malekko VARIGATE 4+ Manual

PROGRAMMING GATES PER STEP

ADJUST GATE/CV SWITCH to 2/2 to enable
CV output on Channels 1 and 3
outputs on channels 2 and 4.
GATE PROGRAMMING:
PRESS THE PLAY BUTTON so the sequence is
playing. By default the sequence will play
forward (and the LED's on the sliders will cycle
top to bottom for each of the 8 steps).
Select CHANNEL button #2 (button will be
illuminated).
The PROBABILITY button will be illuminated
indicating you're ready to start programming
gates per step. Now adjust a slider to the right
to add a gate for a given step (you will also see
each active step light up on the LEDs under-
neath each channel jack). If you move a step
slider all the way to the right, the chance that
that gate will occur is 100%. Setting the slider to
the center and the gate will occur 50% of the
time and so forth.
If you want to change TEMPO, simply select the
TRACK button, then adjust the sliders for
TEMPO.
Now add some REPEATS on a step by pressing
the REPEAT button. Move one of the active
steps to the right to add multiple gates to that
step (great for adding hi-hat rolls for instance).
You can dial exact repeats per step (refer the
LED bargraph for 1-8 repeats per step).
Now repeat the above for CHANNEL #4.
If you want to just program GATES, switch to 4
GATE outs.
VARIGATE 4+ MANUAL V.1
Gate
and
PG. 6
COPY/PASTE:
To copy
programmed step sequence data to another
channel, simply hold down one of the CHANNEL
buttons while selecting another channel button.
and paste newly