Saving And Recalling Presets And Banks - Malekko VARIGATE 4+ Manual

SAVING & RECALLING PRESETS AND BANKS
The CHANNEL buttons also act as PRESET slots as
well as BANK slots. There are a total of 4 preset
slots per bank and 4 banks for a total of 16 preset
slots.
During playback, you will see the active preset
pulsing with tempo.
TO SAVE A PRESET:
Press and hold the SAVE button while you select
one of the CHANNEL buttons to save all sequence
settings programmed on channels 1-4 to one
preset (this includes TRACK mode settings per
channel as well).
TO RECALL A PRESET:
Once you've saved a few different presets, you
can now recall them by holding the RECALL
button while selecting a saved PRESET. The active
preset will pulse. Also note that the recalled
PRESET will play back once the active preset and
all sequences in this preset have completed their
cycles (this includes sequences that have been
divided).
BANKS:
Your first set of saved presets are saved to BANK
1 by default. On power up, BANK 1 will be active
by default as well.
To recall/save presets to BANK 2:
Hold the SAVE + RECALL button for about 1
second until both buttons are illuminated at the
same time. Now press BUTTON #2 to enter BANK
#2, BANK #3 and so forth. Now you can save the
active settings/preset to the available preset slots
in this new bank. Follow the same steps to recall
each available bank of presets.
NOTE: MAKE SURE THAT YOU SAVE ANY EXIST-
ING PRESETS BEFORE SWITCHING TO A NEW
BANK OR YOUR CHANGES WILL BE LOST.
VARIGATE 4+ MANUAL V.1
PG.9
CLEARING PRESETS and CHANNELS:
You can clear a preset by holding the TRACK
button until it is pulsing, then press each CHANNEL
button 1-4 you wish to clear. You can then save that
cleared preset or just start programming new
parameter changes etc.
To overwrite an existing/active preset, simply start
programming changes to parameters and save
again.