Technical Data; Default Settings - Topcom BUTLER 900 User Manual

Symptom
Not possible to dial a number Wrong dial mode
The icon flashes
Base or handset do not ring
Not possible to transfer a call
on PABX
Telephone does not react to
pressing the keys

12 Technical data

Range
Handset Batteries:
Base powersupply
Handset autonomy
Handset talk time
Normal conditions of use
Permitted relative air humid-
ity
Dialling mode
Memories

13 Default settings

Flash time
Dialling mode:
Ring volume
Ring melody
Base PIN
Possible cause
Handset out of range
The base has no power supply
The handset is not registered on
the base
The ringing volume is off or low Adjust the ringing volume
The Flash Time is too short
Manipulation error
up to 300m in open space
up to 50m indoors
2 x 1.2V, 600mAh AAA Type NiMh rechargeable
220/230V / 50 Hz
100 hours in standby
11 hours
+5 °C to +45 °C
25 to 85%
Pulse / DTMF (Tone)
10 indirect with max. 25 digits
100 ms
Tone
Level 3
Ringer 8
0000
Technical data
Solution
see "7.11 Setting the dialling
mode" to set the correct
dialling mode
Bring the handset closer to the
base
Check the mains connection
to the base
Register the handset on the
base
Set the unit to Long Flash
Time
Remove the batteries and put
them back in place
14