Makita TW0350 Technical Information page 5

R
epair
( 4 ) Mount the hammer unit and spur gear 19-41 to the hammer case cover. See Fig. 11.
< Note >
Do not forget to mount flat washers 8 to the following portion.
* Spindle of hammer unit
* Shaft of hammer case cover for spur gear 19-41 (both side of spur gear 19-41)
( 5 ) Mount flat washer 19 and anvil to the hammer case. See Fig. 12.
( 6 ) Mount hammer case cover as illustrated in Fig. 13. The assembling of mechanical section has been finished
at this step.
Flat washer 19
The hammer unit
(hammer, spindle,
compression spring 28, etc.)
Spur gear 19-41
This part can remain
in the hammer case.
Anvil
Fig.12
Flat washer 8
Flat washer 8
Fig.11
Hammer unit
(hammer, spindle,
Hammer case
Hammer case
cover
Hammer
case cover
compression spring 28, etc.)
Fig.13
P 5 / 8