5 Operation LED ..................... 10 LED Status ..................10 Figures F 1 Figure 2.1-1 Vanner Max Illustration ..................3 F 2 Figure 3.4-1 Max Battery Charger Wiring Diagram ..............8 F 3 Figure 4.2-1 Max Three-Stage Battery Charging Graph ............9...
Incorporated Introduction Thank you for purchasing the Vanner Max Battery Charger. We are confident that you will be satisfied with this charger's performance and its many features. With proper installation and care, you can look forward to years of service from this high performance product.
VANNER Owners Manual Incorporated 1.2 Specifications SP00143, SP00180, Model Numbers SP00155 SPC0184 SPC0182 SPC0187 SP00181 Input 15A at 120VAC ±10%, 60Hz ±10% Output 42A at 24VDC Nominal, 4AWG cables DC Current Draw with 30 milliamps None no AC voltage applied milliamps “AC is connected”...
Page 5
WARNING: Before installing and using the MAX Charger, be sure to read and save these safety instructions. This manual contains important safety and operating instructions for the Vanner MAX Battery Charger CAUTION: Read owners manual BEFORE wiring or powering up.
Page 6
To avoid the risk of fire, electrical shock, or injury to persons, do not use attachments not recommended or sold by the Vanner Inc. Vanner recommends that all AC and DC electrical wiring be performed by a licensed electrician or a qualified technician to ensure compliance with all applicable national and local wiring regulations.
VANNER Owners Manual Incorporated To reduce the risk of battery explosion, follow these instructions, the battery manufacturer instructions, and the instructions of the manufacturer of the equipment in which the battery is installed. Working near a lead-acid battery is dangerous. Batteries generate explosive gases during normal battery operation.
VANNER Owners Manual Incorporated 3.2 Charger Mounting • Install the MAX Charger in the horizontal upright position. The charger is furnished with mounting brackets which provide adequate clearance for under chassis airflow. The charger requires under chassis airflow for proper cooling.
BLINKING No LED’s The charger is OFF and is disconnected from both 120VAC and battery. LED Status Indicators for Models SP00155, SPC0182 and SPC0184 Charger Status Yellow solid The charger is ON and is in Bulk Stage or Absorption Stage.