Related Manuals for Vanner VSC12
Summary of Contents for Vanner VSC12
- Page 1 Owner's Manual ¡ £ ¢ ¥ ¤ § ¦ § ¨ § ¤ § ¦ © VSC12/24 BATTERY CHARGER OWNER’S MANUAL D913335-A VCS12/24 Battery Charger Page 1...
- Page 2 ! " # Owner's Manual Notes VCS12/24 Battery Charger Page 2...
-
Page 3: Table Of Contents
! " # Owner's Manual Contents page 1) Description 2) Specification 3) Installation 4) Connections 5) Charging method 6) Thermal Ratings 7) Internal switch settings 8) Internal fuses 9) Standards VCS12/24 Battery Charger Page 3... -
Page 4: Description
! " # Owner's Manual 1) Description • The VSC12/24 is a 1.2kW, 12/24V battery charger intended for vehicle mounted applications. • The output voltage is 12 or 24V nominal, set by internal switches. -
Page 5: Installation
! " # Owner's Manual 3) Installation 3.1) Location • The charger should be located close to the battery (but not in the same compartment) for optimum performance (within 3ft [900mm]). • The charger should be protected from weather. Install the charger in compartments that provide protection from direct water spray, dirt or toxic vapour. - Page 6 ! " # Owner's Manual There are also 4 x 10-32 UNF threaded inserts in the top which may be used to mount another item of weight not exceeding 12.8lbs (5.8kg). Fixing positions as shown below: TOP VIEW 4 x 10-32 UNF threaded inserts...
-
Page 7: Connections
! " # Owner's Manual 4) Connections Connections are made by removing the 10 metric M4 cover fixing screws (4 on top & 3 down each side), removing the cover, & connecting to the terminals on the internal circuit board as shown below: CONNECTOR END OF INTERNAL CIRCUIT BOARD 2 x metric M6 studs... -
Page 8: Charging Method
! " # Owner's Manual The cables must be passed through the appropriate cover holes & secured in strain relief bushes as shown below: CONNECTION END VIEW Holes for 3 x ¾" + 1 x ½" strain relief bushes Remote indication DC output... -
Page 9: Thermal Ratings
! " # Owner's Manual When the battery is charged to the point where the charging current falls below ~75%, a 20 minute timer is started allowing the battery to be fully charged in absorption mode. - Page 10 ! " # Owner's Manual The switches locations are as shown below: heatsink fan end switches heatsink ABCD The switches are the rectangle next to the lower heatsink approximately midway between the two large transformers. The 4 ways are designated A through D, left to right, viewed as in the above diagram.
-
Page 11: Internal Fuses
! " # Owner's Manual 8) Internal fuses 8.1) Input fuse. This is a 1¼” x ¼” 15A 250V UL recognised time delay fuse, mounted in clips behind the ac input terminals. In the unlikely event of this fuse blowing, it is strongly recommended that any faults are investigated &... - Page 12 ! " # Owner's Manual Vanner Incorporated 4282 Reynolds Drive Hilliard, Ohio 43026 1-800-AC Power 1-800-227-6937 Ph: 614-771-2818 Fax 614-771-4904 www.vanner.com Owner's Manual Document Part Number D913335-A April 5, 2006 VCS12/24 Battery Charger...