Quick reference guide
PROGRAM SELECTION
START/RESUME BUTTON
BUTTON
Push this button to start the selected program: the
Push "Programs" button
indicator lights up and goes off at the end of the program.
(repeatedly) until the indicator
When the door is opened during a washing cycle,
of the required program lights
the cycle is temporarily paused: the Start indicator
up (see "Table of programs"
blinks. To resume the cycle close the door and
below).
push Start button again.
Table of programs
P
Programs
1
Pre-Wash
cold
2
Quickwash 45°C
3
2)
50°C
Eco
4
3)
Antibacterial
5
Intensive
70°C
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without
additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor
programs as a result of the appliance's automatic calibration system.
2)
Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information
on the EN/Standard loading comparison test and other tests, contact the following address: "nk_customer@whirlpool.com".
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of
November 2001.
(see at right for options description)
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 -
chapter "What to do if ...".
Available
Loading instructions
options
Delay
Crockery to be washed later.
Lightly soiled crockery, with no dried-
Delay
on food.
Delay
Normally soiled crockery.
Half load
Energy-saving program.
Normally or heavily soiled crockery, with
additional antibacterial wash. Program
Delay
interruption (e.g. due to door opening)
can compromise elimination of germs.
Recommended program for heavily
Delay
soiled crockery, especially suitable for
pans and saucepans.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
Options and display description
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
HALF LOAD BUTTON
Half load cycle can be used
for the upper or lower rack.
Consumption
Select the required program
Deter-
then press the "Half Load"
gent
1)
Litres kWh Minutes
button - the light comes on.
Turns off at the end of the
program. The "Half Load"
—
4.0
0.03
14
option can be used with the
programs indicated in the
table of programs.
X
11.0
0.80
30
X
12.0
1.05
165
TABLET SETTING
X
13.0
1.50
115
This setting allows to optimize the cycle performances
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
X
14.0
1.55
155
tablet (rinse aid, salt and deteregent in 1 dose).
If you are using powder detergent or liquid detergent,
the Tablet indicator on the control panel has to be off.
ADG 8800
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
Chart
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid
dispenser needs to be
refilled.
DELAYED START
BUTTON
The wash cycle can be
programmed to start
after 2, 4 or 8 hours.
Then press the Start
button. The wash
program will start after
the set time.
5019 396 03533
GB -1-