Panasonic FZ-G1 Series Operating Instructions - Reference Manual page 110

The date and time are incorrect.
Battery indicator blinking green.
"Executing Battery Recalibration" screen
appears.
Other startup problems.
Entering Password
Even after entering the password, pass-
word input screen is displayed again.
Forgot the password.
Shut Down
Cannot turn off the computer.
Make the correct settings.
1. Touch
check [Off] in "Set time automatically".
2. Touch [Change], and then set the day and time.
If the problem persists, the internal clock battery may need to be replaced. Contact Panasonic
Technical Support.
<Only for model with LAN>
When the computer is connected to LAN, check the date and time of the server.
The 2100 A.D. or later year will not be correctly recognized on this computer.
In order to stop the battery from deteriorating, power supply from AC adaptor has been shut off, and the
battery power is being consumed. Do not remove the battery pack in this status.
The Battery Recalibration was cancelled before Windows was shut down last time. To start up Windows,
turn off the computer by the power switch
Start in the Setup Utility (
words) to the default values. Start the Setup Utility and make the settings again.
Remove all peripheral devices.
Check to see if there was a disk error.
1. Remove all peripheral devices including an external display.
2. Touch
3. Touch and hold [Windows (C:)], and touch [Properties].
4. Touch [Tools] - [Check].
A standard user needs to enter an administrator password.
5. Follow the on-screen instructions.
<Only if the external keyboard is connected>
The computer may be in ten-key mode.
When Num Lock is on, press ≪ Num Lock≫ to disable the ten-key mode, and then input.
The computer may be in Caps Lock mode.
When Caps Lock is on, press ≪ Caps Lock≫ to disable the Caps Lock mode, and then input.
Enter the password using the same keyboard that was used to set the administrator password
or user password, as the key layouts of the on-screen keyboard and some external keyboards
may differ.
Supervisor Password or User Password:
Contact Panasonic Technical Support.
Administrator password:
If you have a password reset disk, you can reset the administrator password. Set the
disk and enter any wrong password, then follow the on-screen instructions and set a
new password.
If you do not have a password reset disk, reinstall (
Windows, and then set a new password.
Remove all peripherals.
It may take 1 or 2 minutes to turn off the computer.
- 110
(Start) - (Settings) - [Time & Language] - [Date & time], and
, and then turn on.
Setup Utility) to return the Setup Utility settings (excluding the pass-
(Start) - [Windows System] - [This PC].
-
Installing Software) and set up