Kia Seltos 2019 Owner's Manual page 355

What to do in an emergency
7. Place the jack at the front (1) or
rear (2) jacking position closest to
the tire you are changing. Place
the jack at the designated loca
tions under the frame. The jack
ing positions are plates welded to
the frame with two tabs and a
raised dot to index with the jack.
OSP2I069005
OSP2I069006
WARNING
Jack location
To reduce the possibility of injury,
be sure to use only the jack provided
with the vehicle and in the correct
jack position; never use any other
part of the vehicle for jack support.
If you have a flat tire (with spare tire)
8. Insert the jack handle into the jack
and turn it clockwise, raising the
vehicle until the tire just clears the
ground. This measurement is
approximately 30 mm (1.2 in).
Before removing the wheel lug
nuts, make sure the vehicle is sta
ble and that there is no chance for
movement or slippage.
OSP2I069007
9. Loosen the wheel nuts and
remove them with your fingers.
Slide the wheel off the studs and
lay it flat so it cannot roll away.
To put the wheel on the hub, pick
up the spare tire, line up the holes
with the studs and slide the wheel
onto them.
If this is difficult, tip the wheel
slightly and get the top hole in the
wheel lined up with the top stud.
Then jiggle the wheel back and
forth until the wheel can be slid
over the other studs.
7
7 19