Register Your Bt Synergy 3005 - BT Synergy 3005 User Manual

5671 BT Synergy 3005 UG [3]
2. Insert the 2 x AAA NiMH batteries supplied. Then slide
the battery compartment cover into place.
3. Place the handset on the charger to charge for at least
16 hours. The red Charging light comes on. When the
handset is fully charged the display shows a full battery
symbol.
Register your BT Synergy 3005 to the BT Synergy
3105 or 3505 base
If you are registering to another DECT GAP compatible
base station other than the BT Synergy 3105 or 3505,
please refer to that user guide for registering additional
handsets.
Make sure the handset is close to the base.
At the base:
1. Press and hold
about 10 seconds) then release.
All manuals and user guides at all-guides.com
11/11/03
BT Synergy 3005 – Edition 3 – 11.11.03 – 5671
until you hear two beeps (after
Page
4:41 PM Page 7
Talk/Standby time
Under ideal conditions, fully charged
handset batteries should give about
14 hours talk time or 350 hours
standby time on a single charge.
BATTERY LOW WARNING
If the handset battery symbol is
empty and flashing, and you hear
a warning beep every minute, you
will need to recharge your handset
before you can use it.
Battery performance
To keep your batteries in the best
condition, leave the handset off
the base for a few hours at a time
(after the initial 16 hour charge).
New NiMH batteries do not reach
full capacity until they have been
in normal use for several days.
Running the batteries right down
at least once a week will help them
last as long as possible.
The charge capacity of
rechargeable batteries will reduce
with time as they wear out, so
reducing the talk/ standby time of
the handset. Eventually they will
need to be replaced. New batteries
can be obtained from the BT
Synergy Helpline 0870 605 8047.
Getting started 7