Table of Contents
Advertisement
6. On the shift-lever or down tube, fully turn clockwise the barrel-adjuster. Fully turn
clockwise the barrel-adjuster on the rear derailleur, then turn it one turn
counterclockwise.
7. Put the cable into the clamp-bolt groove on the rear derailleur, pull the derailleur
cable tight, and tighten the cable-clamp bolt to 44-60 lb•in (5.0-6.8 N•m).
To adjust the large-cog position
1. Turn the low-gear limit-screw on the rear derailleur (usually identified with an "L")
counterclockwise until the derailleur can move freely.
2. Carefully move the chain to the largest rear cog. Do not move the rear derailleur too
far. The chain can be caught between the large cog and the spokes.
3. Move the rear derailleur pulleys in alignment with the largest cog.
4. Turn the low-gear limit-screw clockwise until it does not turn easily. If you have
turned it too far, the derailleur will move to the outside of the bicycle.
5. Change gears to all the gear combinations. Make sure the chain does not come off
when you change gears.
41
Advertisement
Table of Contents
