Table of Contents
Advertisement
removed for shipping, position the bar in the center of the stem and check, to be sure
that your grips are in the right place and the angle of the bar is comfortable. Tighten
the screws to hold the bar in place, ensuring all brake cables is clear, the suggested
torque is 6-8Nm.
The stem must be inserted to the Minimum depth or lower as indicated on the steer
post to insure the safety. Tighten the stem screw located on the top of the handlebar
stem. You may adjust the handlebar stem angle by loosening the Allen key screw
located underneath the stem. Tighten the stem, adjustment screw securely after
positioning the stem angle. The tightening torque between the handlebar and the frame
stem should be bigger that 10-12Nm.
WARNING
Overtightening of stem screw can cause damage to the steerer of the fork, possibly causing it to break. If the steerer breaks,
you could fall.
Check that the forks and the handlebars are facing forward and straight. Stand at the
35
Advertisement
Table of Contents
