Kenmore 790.4907 Series Use & Care Manual page 11

Consumer Defined Contro
Note: The Consumer Defined ControU features are adjustments to the controU that wHUnot affect cooking resuUts, These
incUude the Oven Lockout, Temperature DispUay and SHent ControU Operation features
Setting Oven Lockout Feature
The @ pad controUs the Oven Lockout feature, The Oven Lockout feature automatbaHy bcks the oven door and prevents
the Oven from being turned on, it does not disabb the dock, Kitchen Timer or the interior oven lights,
mNSTRUCTmONS
To activate the Oven Lockout feature
1, Press and hold _ for 3 seconds (Figure 1
),
v
2, After 3 seconds "LOC" will appear, a beep will sound and "DOOR
LOCKED" will flash in the display, Once the oven door is locked
the "DOOR LOCKED" indicator will stop flashing and remain on
along with the "LOC",
To reactivate norma_ oven operation:
1, Press and hold _ for 3 seconds, A beep will sound, The
"DOOR LOCKED" will flash in the display until the oven door has
completely unlocked and "LOC" has cleared (figure 2),
2, The wall oven is again fully operational,
PRESS DISPLAY
for 3
seconds
for 3
seconds
Figure 1
Figure 2
Setting Silent Contro_ Operation
The DELAYTIME _ and FLEX CLEAN _ pads control the Silent Control operation feature, The Silent Control
v
operation feature allows the oven control to be operated without sounds or beeps whenever necessary, If desired the control
can be programmed for silent operation and later returned to operating with all the normal sounds and beeps,
mNSTRUCTmONS PRESS DISPLAY
To change contro_ from norma_ sound operation to
silent contro_ operation
1, To tell if your range is set for normal or silent operation press and
hold __S_TEA[_,
"0:00" wiii appearand "DELAY" wiii flash in the display
(Figure 3), After 7 seconds ":SP" wiii appear in the display,
(Figure4)
2, Press _ to switch between normal sound operation and
silent operation mode, The display will show either":SP" (Figure 4)
or ":--" (Figure 5),
if ":SP" appears (Figure 4), the control will operate with normal
sounds and beeps, if ":--" appears (Figure 5), the control is in the
silent operation mode,
3, Press <ART_ to accept the change or press @
to reject the
change,
@
for 7 seconds
G
Figure 3
Figure 4
Figure 5
11