Setting The Address Of Erv (Main/Rmc) - Samsung AN026JSKLKN Series Installation Manual

Setting the address of ERV (MAIN/RMC)

1 . Check whether power is supplied to the ERV or not .
- When the power is not supplied to the ERV, there should be additional power supply to it .
2 . Depending on the installation condition of the ERV, each ERV's address (MaIn/RMC) should be set .
3 . Set the ERV's address (MaIn/RMC) by using a remote controller .
- Initial address of the ERV is set as follows; "MaIn:0, RMC:0"
- Set MaIn and RMC address only when it is necessary . When ERV interface module assigns address automatically,
setting the MaIn address is unnecessary and even though the MaIn address is set, the ERV will follow the address
assigned by the ERV interface module .
- Default value will be maintained when you input the numbers that shouldn't be set on each SEG . (If you input any
number in SEG13~24, the value will be ignored . )
- If you input any value on the SEG with "no function", it will be ignored .
4 . Use a wired/wireless remote controller to set the option . When setting the option with wireless remote controller,
receiving module for remote controller is embedded in PBa so there's no need for connecting extra panel .
option No. : 0AXXXX-1XXXXX-2XXXXX-3XXXXX
Option SEG1
Description Page
Indication Details Indication Details Indication
Indication
and Details
0
Option SEG7
Description Page
Indication Details
Indication
and Details
1
Example) To set "MaIn address: 3/ Group channel: 1/ RMC address: B", you may set the option as shown in the following table
(excluding SEG1 and SEG7 which is page option) .
SEG1
0
SEG7
1
• Main address can be set from 0~47 only and if any other values are set, 'communication error' will occur .
• If you set the SEG3 as 0, the ERV will maintain the existing main address even if you input the option value of
CAUtIoN
SEG6 .
• If you set the SEG9 as 0, the ERV will maintain existing RMC address even if you input the option value of
SEG11~12 .
SEG2
Mode Setting main address
0
a
1
SEG8
Setting RMC address
Indication
no function
0
1
SEG2 SEG3
a 1
SEG8 SEG9
- 1
ENGLISH-35
SEG3 SEG4
Details
no function
no main address
address setting
mode
SEG9 SEG10
Details
no function
no main address
address setting
mode
SEG4
-
SEG10
-
SEG5 SEG6
The unit digit of an
10-digit of ERV
ERV
Indication Details Indication
0~4 10-digit 0~9
SEG11 SEG12
Group channel Group address
Indication Details Indication
RMC1 0~2 RMC2
SEG5 SEG6
-
SEG11 SEG12
1
Details
Unit digit
Details
0~F
3
B