Safety Precautions; Severe Warning Signs - Samsung AN026JSKLKN Series Installation Manual

Erv, energy recovery ventilator
Hide thumbs Also See for AN026JSKLKN Series:
Table of Contents

Advertisement

Safety precautions

Keep this installation manual together with the user's manual in a handy place so that you can find it whenever you need to
see it after reading this manual thoroughly .
❇ ❇ Make sure to read the following safety precautions carefully before installation .
❇ ❇ Make sure to observe the cautions specified in this manual .
❇ ❇ Conduct a test run of the unit after installation and then explain all system functions to the owner .
❇ ❇ The indications and meanings are as shown below .
WARNING
CAUTION

SEVERE WARNING SIGNS

f Do not install the unit by yourself . Incorrect installation of the unit could cause injury due to fire, electric shock and water
f
leakage or from the unit falling . Consult a dealer or a qualified installer .
f Place a grille over the air inlet to prevent birds nesting inside .
f
f Do not attempt to repair, move, modify or reinstall the unit on your own . Make sure that these installations are carried out
f
by qualified personnel to avoid electric shock or fire .
f Check if the voltage and the frequency of the main power supply are required for the unit to be installed and check the
f
connection .
f The electric work must be done by service agent or similarly qualified person according to national wiring regulations
f
and use only rated cable . If the capacity of the electric work is not properly completed, electric shock or fire may occur .
f Make sure the air intake is located far from an exhaust port of a burner . It may cause oxygen shortage .
f
f Ground the unit . Do not connect the ground to a gas pipe, water pipe, lighting rod or telephone grounding . Defective
f
grounding could cause electric shock .
f Do not leave electrical connections loose, to do so may cause sparking, heat build up or electrical shock .
f
f Install separate MCCB and ElB when installing the power cable . If you do not install the MCCB and ElB, electric shock or
f
fire may occur .
f If the power plug is damaged, replace it by the manufacturer or qualified personnel to avoid the risk .
f
f Disconnect the circuit breaker when you don't use the product for a long period of time to save energy .
f
f Do not install the electrical cables under tension; doing so may lead to electrical disconnection and attendant problems .
f
f Disconnect the electrical supply before carrying out repairs .
f
f Do not pull the electric wire or touch the power plug with wet hands .
f
f Installers are required to read the general information carefully for safety .
f
f Do not put the product near dangerous substances to prevent fire, explosion or injury and do not expose the product to
f
direct sunlight .
f avoid the use of an extension cord and do not share the power outlet with other appliances . Incomplete connection,
f
defective insulation or exceeding the permissible current may cause electric shock or fire .
f Make sure to turn off the main power when setting up the product's electric circuit or power cords . There is electric shock .
f
f The product should be installed in accordance with the national Electrical regulations .
f
f Ensure that the national safety code requirements have been followed for the main supply circuit . Ensure that a properly
f
sized and connected ground wire is in place .
Hazards or unsafe practices that may result in severe personal injury or death.
Hazards or unsafe practices that may result in minor personal injury (to installer/user) or
property damage.
ENGLISH-3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents