How To Connect Your Extended Power Cables - Samsung AN026JSKLKN Series Installation Manual

How to connect your extended power cables

1 . Prepare the following tools .
tools
Spec
Shape
2 . as shown in the figure, peel off the shields from the rubber and wire of the
power cable .
- Peel off 20 mm of the wire shields of the tube .
• after peeling off the tube wire, you must insert a contraction tube .
• For information about the power cable specifications for indoor and
CAUtIoN
outdoor units, refer to the installation manual .
3 . Insert both sides of core wire of the power cable into the connection sleeve .
f Method 1 f
Push the core wire into the sleeve from both sides .
f Method 2 f
Twist the wire cores together and push it into the sleeve .
4 . Using a crimping tool, compress the two points and flip it over and compress another two points in the same location .
- The compression dimension should be 8 . 0 .
- after compressing it, pull both sides of the wire to make sure it is firmly pressed .
Compression
dimension
Crimping pliers Connection sleeve (mm)
MH-14 20xØ6 . 5 (HxOD)
f Method 1 f
Compress it 4 times .
5 mm
ENGLISH-15
Insulation tape Contraction tube (mm)
Width 19mm 70xØ8 . 0 (lxOD)
Power cable
20
180
Connection sleeve
Connection sleeve
f Method 2 f
Compress it 4 times .
5 mm
20 20
60
120
(Unit: mm)