Trial Operation Of The Erv; View Mode Of Erv - Samsung AN026JSKLKN Series Installation Manual

trial operation of the ERV

trial operation
f Start the trial operation by pressing the KEY1 button below the display (7-segment) . Press the KEY1 button again to end
f
the trial operation .
f f will be displayed on the display 1 during trial operation .
description of ERV display
❇ ❇ If the display is showing "U0 00" as shown above, it means that ERV is communicating normally with a wired remote
controller and its RMC address is "0" and the main address is "00" .

View mode of ERV

f If you press KEY 2, various data will be displayed .
f
f Displayed data will vary as shown in below table, depending on the number of times you press the KEY 2 .
f
Number of pressed
times
1
2
3
4
5
6 number of installed (ERV) units
7
8
9
❇ ❇ Press the KEY2 switch for more than 3 seconds to reset .
❇ ❇ 1)* For the models without CO
❇ ❇ 2)* For the models without humidity sensor, 00 will be displayed on SEG3, 4 .
SEG1: Displays "U" when ERV is communicating with a wired remote controller
SEG2: Displays RMC address of the ERV (0~F)
SEG3/SEG4: Displays the main address of the ERV (0~47)
displayed content
Discharge air fan RPM
Supply air fan RPM
Indoor temperature
Outdoor temperature
CO concentration
1)*
2
Indoor humidity
2)*
Outdoor humidity
2)*
Developer mode
sensor, 00 will be displayed on SEG3, 4 .
2
ENGLISH-25
Example
SEG1
1,350 RPM 1
950 RPM 2
25 °C 3
30 °C 4
1,220 ppm 5
3 units 6
40 7
50 8
display on segment
SEG2 SEG3 SEG4
1 3 5
Off 9 5
Off 2 5
Off 3 0
1 2 2
Off 0 3
Off 4 0
Off 5 0