Technical Specifications - Jorc SmartGuard Installation & Maintenance Instructions Manual

TECHNICAL SPECIFICATIONS

Max. compressor capacity
Min. / Max. system pressure
Min. / Max. medium temperature
Valve type
Valve orifice
Inlet connection + height
Outlet connection + height
Valve seals
Supply voltage options
Connectors
Serviceable valve
TEST feature
Environmental protection
Integrated mesh strainer
Alarm feature type
Alarm feature specification
100 m³/min.
0 Bar / 16 Bar
1° C / 50° C
2/2 way, direct acting
4 mm
1/2" BSP or NPT, 11 cm (top) and 7.5 & 1.5 cm (side)
1/2" BSP or NPT, 4.3" (top) and 2.9" & 0.6" (side)
1/4" BSP, 1.5 cm (side)
FPM
230VAC or 115VAC or 24VAC or 24VDC (See label on unit!)
DIN 43650-B
Yes
Yes
IP65 (NEMA4)
Yes
Contact output switch (voltage free) available in two versions: A1 and A2
A1 = Normally open contacts, closed when in alarm phase. Light on the
drain is OFF when in operation and ON when in alarm mode.
A2 = Normally closed contacts, open when in alarm phase. Light on the
drain is ON when in operation and OFF when in alarm mode.
Max. 230VAC, max 4A, 1000VA
or 200VDC, 100W and min 5VDC, 100mA
10
3500 cfm.
0 Psi / 230 Psi
34° F / 122° F
0,157"
1/4" BSP, 0.6" (side)