Table of Contents
Advertisement
Available languages
Available languages
11.2. GLASS CLEANING
Through a specific secondary air inlet, the formation of deposits of dirt, on the door glass, is effectively slowed down. It cannot, though, ever
be avoided with the use of solid fuels (e.g. damp wood) and this should not be considered a defect of the appliance.
IMPORTANT: the cleaning of the panoramic glass must only be carried out when the device is cold, in order to prevent it exploding. Do not
use cloths or products which are abrasive or chemically aggressive.
The correct lighting phase, the use of proper quantities and types of fuels, the correct position of the secondary air regulator, enough
draught of the chimney-flue and the presence of combustion air are the essential elements for the optimal functioning of the appliance and
for the cleaning of the glass.
GLASS BREAKAGE: as the glass parts are in ceramic glass, resistant up to a sudden thermal change of 750°C, they are not
subject to thermal shocks. Their breakage can only be caused by mechanical shocks (knocks or violent door closing etc.).
Therefore replacement is not covered by the warranty.
11.3. ASH DRAWER CLEANING
All LA NORDICA devices have a furnace grill and a drawer for ash collection. It is advisable to empty the ash drawer periodically and
prevent it filling up completely, so as not to overheat the grill. In addition, it is advisable to always leave 3-4 cm of ash in the furnace.
CAUTION: the ash removed from the furnace must be replaced in a recipient for fireproof material equipped with an airtight cover. The
recipient must be placed on fireproof flooring, away from flammable materials until the ash is completely out and cool.
IMPORTANT: if for whatever reason the grill is removed from the furnace, take care to reassemble it with the wider part of the slit facing
Picture 6 at page
downwards (See
11.4. MAINTENANCE ON THE WATER SYSTEM
With the system switched off, once a year carry out the following checks:
• Check the operation and efficiency of the blowdown and safety valves. If they are defective, contact your authorised installer. IT IS
STRICTLY FORBIDDEN TO REMOVE OR TAMPER WITH THE SAFETY DEVICES.
• Check the thermal insulation of the filling pipe and the safety pipe.
• Make sure that the system is filled and under pressure, checking the water level in the expansion tank; also check that it is working
properly and check the efficiency of the safety pipe.
12. SUMMER SET ASIDE
WARNING: The system should be kept constantly full of water even in periods in which the use of the wood burning stove/cooker is not
required. During the winter, inactivity must be faced with the addition of antifreeze.
After having cleaned the furnace, the chimney and the flue, ensuring total elimination of the ash and other residues, close all the furnace
doors and respective registers and disconnect the appliance from the chimney.
It is advisable to carry out the flue cleaning operation at least once a year; in the meantime, check that the seals are in good condition as,
if not perfectly intact, they do not guarantee good appliance operation! In this case, it is necessary to replace them.
If appearance is to be maintained over time, protect the cast iron parts with neutral Vaseline.
26
54). This is to aid furnace cleaning.
ITALY TERMO - BUILT IN - DSA
7095703 - IT-EN-DE-FR
Advertisement
Table of Contents
