Pepperl+Fuchs NVD-111 Manual page 33

Warning Device NVD-111
Commissioning
The following table contains a list of possible configuration settings.
Switches
DIP 1 Reaction time (reaction
time of the fat level
sensor)
DIP 2 Overflow sensor KVF-O
DIP 3 Fat level sensor KVF-F
or FAU-104
DIP 4 Acoustic alarm
DIP 5 Relay setting
DIP 6
DIP 5 Relay setting
DIP 6
DIP 5 Relay setting
DIP 6
DIP 5 Relay setting
DIP 6
DIP 7 Repeat alarm in 24
hours
DIP 8 Reset key (ALARM
RESET activation)
Description
ON Operating mode – delay of the sensor reaction
OFF Service/test mode – instant sensor reaction
ON connected
OFF not connected
ON connected
OFF not connected
ON Acoustic alarm on.
OFF Acoustic alarm off.
ON Relays 1 and 2 switch irrespective of the alarm states and
with which sensor. If the alarm status disappears, relays 1
ON
and 2 switch again (if "ALARM RESET" is actuated, the
relays switch again).
ON Relays 1 and 2 switch, irrespective of the alarm states.
After 3 minutes, relay 2 switches again (even if an alarm
OFF
status is present). If the alarm status disappears, relay 1
and/or relay 2 switches again (if "ALARM RESET" is
actuated, the relays switch again).
OFF In the case of active alarm status, relay 1 switches to
overflow sensor KVF-O and relay 2 switches to fat level
ON
sensor KVF-F/FAU-104. If the alarm status disappears,
relay 1 and/or relay 2 switch again (if "ALARM RESET" is
actuated, the relays switch again).
OFF Relays 1 and 2 switch, irrespective of the alarm states. If
an alarm event is no longer present, relay 1 automatically
OFF
switches back and relay 2 remains unchanged until the
alarm is cleared by actuating "ALARM RESET". It shows
that an alarm occurred.
ON Repeat alarm on. This also applies to the function of
relays 1 and 2.
OFF Repeat alarm off.
ON "ALARM RESET" button is activated. The acoustic alarm
and the alarm relay can be reset.
OFF "ALARM RESET" button is deactivated. The acoustic
alarm and the alarm relay cannot be reset.
EN
EN - 31