Reolink C1 User Manual page 31

 NTP Server: The server you intend to use to access the current date and time. The
default is pool.ntp.org.
 NTP Port: The port that the NTP server uses.
Enable Auto-Synchronize: enable or disable auto-synchronization.

 Synchronize Every: Set the Sync interval time.
Click Synchronize to synchronize the time now, click OK to save and enable settings.
NOTE:
1. If you have enabled NTP - set this to the time zone where you are.
2. Some NTP servers are NOT fully compatible with DST (Daylight Savings Time). This
may cause your system to double-count adding one or removing one more hour than
they should, or cancel each other out. You may need to change your time zone to adjust
accordingly or simply not use NTP and DST simultaneously.
Email Setup
Click the Setup button next to E-mail to enter the setup page.
 Enable SSL or TLS: Whether the email server you're using requires a secure link.
This is on by default and should be left on if you're using any of the preset email
servers.
 SMTP Server: Type in the SMTP server for the sender Address. The default server is
for Gmail.
 SMTP Port: Set the correct port number for the SMTP server you use. The default
value is the port number for Gmail.
 Sender Address: The address you're sending the email from. Type it in the format
youraddress@gmail.com (please
account).
 Password: The password for the Sender email account.
Recipient Address: The email address you want the Camera to send emails to. You

can specify up to three recipient E-mail addresses.
NOTE, the email address should be your own email
25