Sony WG-C10 Help Manual page 201

4-468-627-14(1)
© 2013 Sony Corporation
4. If necessary, enter the password of the device you want to connect to, then tap
[OK].
If you want to connect to a wireless LAN of which the security has been set,
password entry may be required.
The unit restarts and is connected to the wireless LAN access point.
Hint
Tap the SSID connected in step 3 or a registered SSID, to display its network
information.
A maximum of 6 SSIDs of wireless LAN devices are automatically registered. Tap the
SSID connected in step 3 or a registered SSID, to display its network information. To
unregister an SSID, tap [Forget this Network] on the information screen of the
wireless LAN device.
Note
When using at home, an Internet connection and wireless LAN router are required.
When using outside the home, check the wireless LAN situation of the location
through the public wireless LAN service provider's website, etc. Using such services
may require a separate contract with the service provider.
Connection to all public wireless LAN services is not assured.
Wireless LAN exchanges information by radio wave, allowing easy access within the
communication range. Consequently, if security settings are not made, there is a risk
that a third party on the same network could maliciously access (hack into) your unit.
Setting security is your decision and responsibility, and is strongly recommended.
It may take time to establish connection, or connection may not be established,
depending on the usage environment.
It is not possible to connect to any wireless LAN device with a hidden SSID.
Go to Page Top
Notes on use
193