Siemens MTE-2 Installation Instructions

Installation Instructions

Model MTE-2
(for indoor use only in dry environments)
The Model MTE-2 from Siemens Industry, Inc.
is an enclosure assembly that accommodates
up to six remote telephones.
Fasten the enclosure securely to a clean, dry,
shock-free, and vibration-free surface. Con-
sider the following when mounting the box.
—Mounting height for visual and manual
access to the telephones in the enclosure
—A location that provides easy access to
the remote telephone jacks
—Weight and size of the enclosure
—Local mounting codes
When mounting, position the backbox clear of
obstruction so that the door can open freely
and so that the contents are easily accessible.
Siemens Industry, Inc.
Building Technologies Division
Florham Park, NJ
P/N 315-093304-5
A
A
Enclosure for the MTE-2
TO INSTALL THE MTE-2
1. Slip the door off the hinges of the box and
put it to one side temporarily.
2. Cover the opening in the door by placing
the clear lens over the studs on the door.
3. Fasten the lens to the door using the six
6-32 nuts provided.
4. (Refer to Figure 1.) Place the telephone
cradles plate over the standoffs (marked A)
located near the top of the enclosure.
5. Fasten the plate to the standoffs using the
four 4-40 x
6. Hold the empty enclosure against the wall
at a height that provides easy access.
A
Figure 1
Siemens Building Technologies, Ltd.
Fire Safety & Security Products
2 Kenview Boulevard
Brampton, Ontario L6T 5E4 CN
1 /4
" screws provided.
A