Summary of Contents for Rollplay 6V PJ Masks Cat Car W419AC-B
Page 1
® 6V PJ Masks Cat Car Owner’s Manual and Assembly Instructions Model #: W419AC-B Read and understand the entire manual before assembly and operation. The vehicle must be assembled by an adult who has read and understands the instructions. Made in China. Styles and colors may vary.
Page 2
Introduction Thank you for purchasing this Rollplay vehicle. We hope the rider enjoys it for miles to come. Please read this instruction guide carefully before assembling and operating the vehicle. Please have your model number and serial number ready before calling. Please have proof of purchase.
Page 3
Call Customer Service if you need assistance or replacement parts. Please have your model number and serial number ready before calling. Please have proof of purchase. Keep your sales receipt or register your product at www.rollplay.com as we may require proof of purchase. 1-888-982-9309 Read this entire manual to ensure proper assembly and safe operation of the vehicle.
Table of Contents Safety ..................Parts ................... Charging Instructions ............................Install the Frames ............... Install the Front Wheels............Install the Right Rear Wheel ............Install the Left Rear Wheel ............Install the Steering Wheel ............Connect the Power Supply ................
Safety WARNING: SAFETY RIDING RULES The user must follow all safety rules and guidelines, or serious injury or death may occur to the user. • Always use common sense and safe practices when using the vehicle. The user must be at least 3 years old and weigh no more than 30 kg(66 lb). •...
Page 6
Safety (Continued) WARNING: BATTERY SAFETY • Battery posts, terminals and related accessories contain lead and lead compound (asic) chemicals known to the state of California to cause cancer, reproductive harm, and are toxic and corrosive. DO NOT open the battery. •...
Charging lnstructions YOU MUST CHARGE THE BATTERY FOR 24 HOURS BEFORE THE FIRST USE! ONLY AN ADULT SHOULD HANDLE THE BATTERY AND CHARGER. 1. The charging input socket is in the fuel tank cap 2. After the first time, you should charge the battery for 8-12 hours. Do not recharge the battery for more than 20 hours to avoid overheating the charger.
Install the frames Support frame(Left and Right) ST4.2x12 screw Back bumper frame 1. Turn the vehicle on its back. Locate the frames from the packaging. 2. Install the left and right support frame on the corresponding sides of the vehicle. Align the holes on the frames with the holes on the vehicle body.
Install the front wheels 12 Washer Wheel 12 Washer Split pin Front axle Wheel cover Axle sleeve 1. Locate the front wheels and the axle sleeves from the packaging. Install an axle sleeve on either side of the front wheels by inserting the sleeve into the hole on the front wheel.
Install the right rear wheel Wheel cover Axle sleeve Gear box Snap pin 12 Washer Rear axle Driving wheel 1. Locate the driving wheel. Install an axle sleeve on the front side of the wheel by inserting the sleeve into the hole on the front wheel. Push in the axle sleeve completely.
Install the left rear wheel Axle sleeve 12 Washer Snap pin Wheel 12 Washer Wheel cover Rear axle 1. Locate the left rear wheel. Install an axle sleeve on either side of the wheel by inserting the sleeve into the hole on the wheel. Push in the axle sleeve completely.
Install the steering wheel Steering wheel M5x35 Bolt M5 Nut 1. As shown in the picture, remove the nut and bolt from the steering wheel with a screwdriver. 2. Insert the steering wheel onto the steering wheel axle so the holes on the steering wheel align with the holes on the axle.
Connect the power supply Motor connector Wire connector Wire connector B Fuel tank cap Wire connector A 1. As shown in Figure 1, locate the wire connector and motor connec tor in the battery compartment. Connect the two connectors. 2. As shown in Figure 2, open the fuel tank cap and connect Wire Con nector A to Wire Connector B.
Install the seat M4x30 Bolt Seat 1. As shown in the picture, slide the seat over the battery compart ment. 2. Use two bolts to secure the seat and use a screwdriver to fasten tightly.
Install the windshield and vent hole Windshield Vent hole 1. Insert the windshield into the slot on the car body as shown in Figure 1 until it snaps into place. 2. Install the vent hole on the rear of the vehicle as shown in Figure 2.
Install the battery WARNING! DO NOT mix old and new batteries. DO NOT mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. 1. Using a screwdriver, loosen the screw on the battery cover of the steering wheel. Remove the cover. 2. Insert 2 AA batteries, and replace the battery cover.
Operating instructions IMPORTANT! Sound Always stop vehicle Pedal Switch when changing the speed or direction to Power Switch avoid damage the gear box and motor. Forward/ Reverses Switch POWER SWITCH: Turn the vehicle ON or OFF FORWARD/REVERSE: Press the switch to "Forward." Then press the foot pedal to drive forward.
Maintenance Important Battery and Charger Information • Only an adult who has read and understands the safety warnings may handle and operate the battery and battery charger. Keep away from children. • time. • Recharge the battery immediately after each use. Charge for at least 8-12 hours, but no more than 20 hours.
General Care • Regularly inspect all vehicle parts to ensure they are in good working condition. • Regularly inspect the charger, cord, plug, and other related parts for damage. • Remove any damaged parts and immediately contact Customer Service for replacement parts. See Service information on Page 23. •...
Troubleshooting Guide Completely read through the manual and troubleshooting guide before contacting Customer Service. Problem Potential Cause Solution Vehicle does not run Battery is low Recharge the battery Thermal fuse tripped Reset fuse Loose wires or loose Ensure the battery connectors are connectors securely attached.
FCC Information This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Hours: 9 AM - 5 PM (CST), Monday - Friday 888-982-9309 Phone: 1- Email: customerservice@rollplay.com Web: www.rollplay.com For a list of available replacement parts, please visit www.rollplay.com. WE WILL REQUIRE PROOF OF PURCHASE. Please save your sales receipt or register your product at www.rollplay.com.
This warranty does not cover, and is not intended to exclude any liability on the part of Rollplay, whether under this warranty or implied by law for any indirect or consequential damages for breach of warranty. Some states may not allow the exclusion or limitation so this limitation may not apply to you.
City: State: Zip Code: Email: Phone: Date of Purchase: The following product information is on the cover of the owner’s manual. Product Name: Model Number: Serial Number: Retailer Place of Purchase: Questions or comments? Contact us at www.rollplay.com or 1-888-982-9309...
Need help?
Do you have a question about the 6V PJ Masks Cat Car W419AC-B and is the answer not in the manual?
Questions and answers
How to replace the battery. The car will not hold a charge.