Gas Cylinder; Technical Data - Napoleon PATIOFLAME Series Manual

recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
Correct Disposal Of This Product
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
please use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
Gas Cylinder
Never connect a cylinder, which does not meet local codes.
Use only gas cylinders, which meet national and regional codes. The minimum cylinder size for butane
units is 13kg, and for propane units is 6kg. Ensure that the cylinder can provide enough fuel to operate the
appliance. If in doubt, check with your local gas supplier.
cylinders connected to the appliance may be stored in the enclosure, or close to the appliance. Spare
• Use caution when handling the cylinder valve.
•
must not be exposed to extreme heat or direct sunlight.
• All cylinders 7kg or larger must be placed outside the enclosure on level ground. Cylinders smaller
than 7kg (maximum size 465mm high by 306mm wide) may be placed inside the enclosure. Only
cylinders must not be stored in the enclosure, or in close proximity of an operating unit. Cylinders
Cylinder Connection: Remove the cap or plug from the cylinder fuel valve. Tighten regulator to cylinder
valve. Leak test all joints prior to using. A leak test must be performed annually, and each time a cylinder is
Ensure that the hose is routed to maintain proper clearance to the underside of the
WARNING!
unit. Hoses that contact high temperature surfaces may melt and leak, causing a fire.
If the hose and regulator are not included by the manufacturer, then only hoses and regulators which
hooked up, or if a part of the gas system is replaced.
Gas Hose
Ensure that the gas hose does not come into contact with any hot surfaces on the appliance -
•
The recommended hose length is 0.9m. The hose must not be longer than 1.5m.
meet national and regional codes are to be used.
•
Replace the hose before expiry date printed on the hose.
particularly the underside of the burner.
• Check hose regularly. In the case of rips, melting or wear, replace hose before using the appliance.
•
The following table lists input values for the appliance.
• Ensure that the hose is twist and kink free when installed.
•
I II III
Technical Data
Gas Category
3B/P(30)
Orifice Size
I
I
above) #51 #53 #36
Gases / Pressures Butane and
Certified Gases / Pressures - Check rating plate to ensure that it corresponds with following list.
Propane at
30mbar
Orifice Sizes(see
Countries BE, BG, CY, DK,
EE, FI, FR, GB,
NO, RO, SE, SI,
SK, TR
HR, HU, IS, IT,
LT, LU, MT, NL,
Do not tamper with or modify regulator. Use only regulators which supply the pressure listed in the table
above. For replacement, use only the regulator specified by the manufacturer.
3+(28-30/37) 3B/P(50)
(Gross) Heat Input (Total)
I I I
I II III
11.5 kW
Butane 28- Butane G20 at 20mbar
30mbar Pro- and Pro-
2H
pane 37mbar pane at
50mbar
ES, FR, GB, GR, DE, SK EE, ES, FI, GB, GR,
PT, SK, SI LT, NO, PT, RO, SE,
SI, SK, TR
BE, CH, CY, CZ, AT, CH, AT, BG, CH, CZ, DK,
IE, IT, LT, LU, LV, HR, HU, IE, IS, IT, LV,
5
I/II III
2E 2E+
Gas Usage (Total)
I I
III III
837 g/hr 1092 L/hr
G20 at G20/G25
20/25 at 20/25
mbar mbar
BE,FR
PL
DE, LU,
www.napoleongrills.com
EN