Maintenance / Cleaning Instructions - Napoleon PATIOFLAME Series Manual

Maintenance / Cleaning Instructions
Glass embers may have sharp edges, wear safety glasses and gloves when handling.
WARNING!
Do not change or substitute the glass ember material provided with this appliance. If replacing, use
only replacement glass embers available from your local authorized dealer / distributor.
WARNING! To avoid the possibility of burns, maintenance should be done only when the
coastal areas and other harsh environments, such as the warm, highly humid atmosphere around pools
appliance is . Avoid unprotected contact with hot surfaces. Ensure burner is turned off. Turn gas off at
and hot tubs. These stains could be perceived as rust, but can be easily removed or prevented. To provide
source and disconnect the appliance before servicing. Clean the appliance in an area where cleaning
solutions will not harm decks, lawns, or patios. Do not use flammable, corrosive or abrasive cleaners.
required with fresh water and/or stainless steel cleaner.
Note: Stainless steel tends to oxidize or stain in the presence of chlorides and sulfides, particularly in
Control Panel: The control panel text is printed directly on the stainless steel and with proper
cleaner available from your Napoleon dealer. Never apply abrasive cleaners on any stainless surfaces,
stain prevention and removal, wash all stainless steel and chrome surfaces every 3-4 weeks or as often as
maintenance will remain dark and legible. To clean the panel, use only warm soapy water or stainless steel
especially the printed portion of the control panel or the printing will gradually rub off.
WARNING! Hose: Check for abrasions, melting, cuts, and cracks in the hose. If any of these
conditions exist, do not use the appliance. Have the part replaced by your Napoleon dealer or qualified
gas installer.
Cleaning Inside The Appliance: While washing your appliance, be sure to keep the area around the burner
and pilot assembly dry at all times.
Burner: The burner is made from stainless steel, but extreme heat and a corrosive environment can cause
surface corrosion to occur. This can be removed with a brass wire brush. Inspect the burner at least
If the gas control is exposed to water in any way, DO NOT try to use the appliance.
WARNING!
The gas control must be replaced.
annually for cracks, insect nests, excessive corrosion or any other damage. If the burner is damaged, it
must be replaced with a burner specified by the manufacturer before the appliance is put into operation.
CAUTION!
Beware of Spiders.
signs that may indicate a problem are:
Spiders and insects are attracted to the smell of propane and natural gas. The burner is equipped with an
Strong or unusual odor coming from the appliance.
insect screen on the air shutter, which reduces the likelihood of insects building nests inside the burner
but does not entirely eliminate the problem. A nest or web can cause the burner to burn with a soft yellow
or orange flame or cause a fire (flashback) at the air shutter underneath the control panel. Other warning
Flame appears either very short or very long.
Flame only burns part way across the burner.
•
Excessive soot building up on the glass embers.
• Continued difficulty or delayed ignition.
To clean the inside of the burner, it must be removed from the appliance: Remove the glass embers and
•
examine the burner. If dirty, clean with a wire brush.
•
•
are easier to clean if the burner is removed from the appliance, but it can also be done with the burner
installed.
Cleaning: Use a flexible venturi tube brush to clean the inside of the burner. Shake any loose debris from
the burner through the gas inlet. Check the burner ports and valve orifices for blockages. Burner ports can
close over time due to debris and corrosion; use an opened paperclip or a drill bit to clean them. The ports
13
EN
www.napoleongrills.com