Conversion To Natural Gas - Napoleon PATIOFLAME KENS1 Manual

10

Conversion to Natural Gas

!
WARNING!
EN
flame is cool. Ensure burner is turned off. Turn gas off at source and disconnect the patio flame before
beginning conversion.
WARNING!
!
WARNING!
be leak tested before operating the patio flame.
Your patio flame can be easily converted to natural gas by following these steps:
1. Remove the glass embers from the burner.
2. Remove the burner from the enclosure. Take care not to damage or kink the thermocouple wire.
3. Disconnect the stainless steel flex connector from the orifice using (2) wrenches.
4. Unscrew the propane orifice from the inside of the burner as illustrated.
!
5. Replace the propane orifice with the natural gas orifice supplied.
Note: The air shutter has been factory set and does not need to be adjusted.
www.napoleon.com
To avoid the possibility of burns conversions should only be done when the patio
Glass embers may have sharp edges wear safety glasses and gloves when handling.
This conversion must be performed by a licensed gas fitter, and all connections must
KENS1
KENS2
(GPFR)
(GPFS)
KENS3 (GPFC40)
N415-0500 OCT 18.21