Jura Impressa X9 Manual

Dimo Espresso Services
Jura Impressa X9 Descaling Process
Your IMPRESSA X9 Coffee maker machine builds up deposits of limescale over time and
automatically prompts you to descale it when necessary. The degree of calcification depends on
the degree of hardness of water at location machine is in use.
CAUTION

If the wrong descaling agent is used, the machine could be damaged and/or traces of
detergent could be left behind in the water. Use only original JURA care products.

Once started, the descaling operation must not be interrupted. If the descaling
operation is interrupted, there may be damage to the machine.

Allow the descaling program to run to the end. The descaling program lasts approx.
45 minutes.

If you use a CLARIS filter cartridge and this is activated meaning that
programmed in filter
prompted to descale the machine. In this case descaling operation can only be started by
Jura or any specialized service technician.

If you are using a CLARIS filter cartridge, you must always remove it before
descaling. Do not descale the machine if a CLARIS filter cartridge is fitted.
Your IMPRESSA machine is ready for descale operation, when the message
is shown on the display.
Note:
We recommend that to descale machine within the same day that message appears on display. If
you make more coffees, the display will indicate: DECALCIFY. After yet even more coffees made,
the display will read:

Open the cover of the programming buttons on front. As it
is shown in the picture and then press.....
mode, or the water hardness is set to 'not active', you will not be
DECALCIFY NOW.
the machine is
COFFEE READY
DESCALE