Securing The Child - Evenflo Secure Kid Owner's Manual

Securing the Child

IMPORTANT: The child's back and bottom should be flat
against the restraint. If there is a gap, the child will not be
comfortable.
28
1. Loosen harness.
Press the harness release
button on the front of
the seat while pulling
the harness straps.
2. Position harness
straps.
Unfasten chest clip and
place the child in the
child restraint.
Bring each harness strap
over the child's shoulders.
3. Buckle the harness.
Insert both buckle
tongues into the buckle.
Note: Pull up on the
harness straps to ensure
that the buckle tongues
are fastened securely.
5. Tighten harness.
Pull the harness adjuster strap to tighten the harness.
Note: Check the harness straps near the shoulders for
slack. You should NOT
(see illustration). Adjust as needed.
IMPORTANT: A snug strap should not allow any slack.
It lies in a relatively straight line without sagging. It does
not press on the child's flesh or push the child's body into
an unnatural position.
Securing the Child
4. Fasten and adjust
chest clip.
Snap the two halves of
the chest clip together,
as shown, and slide to
armpit level.
be able to pinch the harness
29