Evenflo Secure Kid Owner's Manual page 15

Installation with Vehicle Seat Belt
Locking Clip
installed properly
13 mm
(0.5 inch)
If your vehicle is model year 1996 or newer, it likely
has a vehicle belt system that can be locked when
tightened, and will not require use of a Locking Clip.
Consult your vehicle owner's manual before
installing a locking clip.
If your vehicle requires a Locking Clip, please call
ParentLink at 1-800-233-5921 (U.S.) or 1-937-773-3971
(Canada), or 01-800-706-12-00 (Mexico) to obtain a
Locking Clip and instructions on how to install and use
it. to obtain a Locking Clip and instructions on how to
install and use it.
WARNING
• Remove Locking Clip from vehicle seat belt when not
used with a child restraint, or the vehicle seat belt will not
properly restrain an adult or child. Serious injury could
occur.
• DO NOT use a Locking Clip in booster mode.
26
5. Remove all slack
from the seat belt.
Using your full weight,
push the child restraint
firmly into the vehicle
seat while tightening
the seat belt to remove
excess slack.
6. Install Locking Clip
(not included), if
necessary.
If your vehicle was built
prior to model year
1996, and has a lap/shoul-
der belt that is equipped
with an emergency locking
retractor (ELR) AND sliding
latch plate, you MUST
a Locking Clip. Check your
vehicle owner's manual to
identify which vehicle belt
system is in your vehicle.
Installation with Vehicle Seat Belt
Upper Belt
Path
IMPORTANT: To properly secure this child restraint, it
MUST NOT move more than 25 mm (1 inch) from side-to-
side or from front-to-back at the upper belt path. If you
can not tightly secure the child restraint, try again or move
it to another location.
use
IMPORTANT: If your tether strap is too short to reach from
your child restraint to your vehicle tether anchor, you will need
a Tether Extender. Please call ParentLink at 1-800-233-5921
(U.S.) or 1-937-773-3971 (Canada), or 01-800-706-12-00
(Mexico).
Your child restraint is equipped with one of two types of
tether adjusters: standard (shown above) or the TruTether
(shown below). If your child restraint is equipped with the
TruTether adjuster, refer to page 44 for information about
proper tightening.
Tightness Indicator
7. Ensure child
restraint is secure.
Hold the child restraint
near the upper belt path,
as shown, and try to
move it in all directions.
8. Connect and tighten
Tether Strap.
Connect the Tether Hook
to the anchor behind
the vehicle seat, as
shown. (Please consult
your vehicle owner's
manual, as tether anchor
locations may vary.)
Pull the strap and tighten
the Tether securely.
Notice
TruTether Adjuster
Display
27