Evenflo Secure Kid Owner's Manual page 10

Installation with Lower Anchor Hooks
Tether Strap
2. Place the child restraint in position.
Set child restraint on vehicle seat in forward-facing
position, as shown. Lay the tether strap over the
back of the vehicle seat.
Near Side
Lower Anchor Bar
3. Attach Lower Anchor Hooks.
Attach a LATCH Hook Connector onto each seat
anchor.
IMPORTANT: Make sure both LATCH connectors are facing
upward and the harness straps are not twisted.
16
Far side
Lower Anchor Bar
Installation with Lower Anchor Hooks
Upper
Belt Path
IMPORTANT: To properly protect the child, the child
restraint MUST NOT move more than 25 mm (1 inch) from
side-to-side or from front-to-back at the upper belt path.
If you cannot tightly secure the child restraint, try again or
move it to another location.
5. Connect and tighten tether strap.
Connect the tether hook to the anchor behind
the vehicle seat, as shown.
Pull the strap and tighten the tether securely.
IMPORTANT: If your tether strap is too short to reach from
your child restraint to your vehicle tether anchor, you will need
a Tether Extender. Please call ParentLink at 1-800-233-5921
(U.S.) or 1-937-773-3971 (Canada), or 01-800-706-12-00
(Mexico).
Notice
Your child restraint is equipped with one of two types of
tether adjusters: standard (shown above) or the TruTether
(shown below). If your child restraint is equipped with the
TruTether adjuster, refer to page 44 for information about
proper tightening.
TruTether Adjuster
Tightness Indicator
Display
4. Secure the child
restraint.
Using your full weight,
push the child restraint
firmly into the vehicle
seat while pulling up
on the LATCH strap to
tighten.
17