Placing The Cap2600; Vehicle Preparation - Capelec CAP2600 User Manual

III Placing the CAP2600

3.1 Vehicle preparation

Firstly, check the tyre pressure. If the pressure is not correct, either inflate or deflate to the
recommended pressure within the - 0 bar and + 0.3 bar limit. In all cases, the pressure must be
balanced.
For vehicles fitted with discharge lamps, operate the windscreen wiper system when the lamps
are lit.
Move the vehicle forward at low speed, gently stop the vehicle in the lamp checking zone with
the wheels straight. Otherwise (for example after an axle check), the vehicle should be
advanced the equivalent of one wheel circumference (without constraints on the axles) and then
gently stopped.
For vehicles with non traditional suspension (e.g. servo suspension), the engine must be started
before carrying out any measurements, and the vehicle must be stabilised with the engine
running.
Put on the handbrake (progressively for manually controlled brakes) or, for automatic models,
place the gear stick in the P position (Park).
When the vehicle is fitted with a manual lamp adjustment system, either inside the vehicle or on
the lamps, place the system in the position set by the manufacturer depending on the load. If
the system is not operational, the control is carried out in the current configuration.
29/06/16 Rev C
6