IV. Control
In the control menu
process.
Step: Controlling dipped beam lamps
During this step you will control the left and right side lamps of the vehicle.
First you must position the CAP2600 in front of the headlamp to be controlled. (See chapter III).
1
The example above corresponds to the measurement of the left dipped beam lamp. The measured vales
displayed in red indicate a value that is outside the statutory limits.
Step: Controlling the fog lamps
During this step you will control the left and right side fog lamps of the vehicle.
First you must position the CAP2600 in front of the headlamp to be controlled. (See chapter III).
1
2
29/06/16
, the CAP2600 will guide you through the entire vehicle headlamp control
2
3
4
3
10
1
2
3
4
1
2
3
Rev C