CDI CD42-STS User Manual page 31

Tighten each screw with Allen wrench in a rotating cross pattern (shown
below) in 20 inch-pound increments. (If using a powered driver, avoid
over-tightening).
6
6
3
3
Continue until the cap screws reach 60-inch pounds torque. After reach-
ing the 60-inch pound level continue the torque pattern and torque to
70-inch pounds. This is the final torque level.
The CPA configuration is complete.
CD42-STS Subsea Diver/ROV Pig Location and Tracking System
1
1
Page 31 of 36
5
5
4
4
2
2