KYORITSU KEW 6300 Driver Installation

Power meter

(1) Connect one end of a USB cord to your PC.

(2) Set the Function switch on the instrument to SET UP range,

and connect the other end of USB cable to the instrument.

(3) When your PC and the instrument are connected properly, the following figure appears.

Select "Locate and install driver software (recommended)".

(4) Select "Don't search online".

USB Driver Installation

Table of Contents

Do you have a question about the KEW 6300 and is the answer not in the manual?

Page 1: Usb Driver Installation
USB Driver Installation (1) Connect one end of a USB cord to your PC. (2) Set the Function switch on the instrument to SET UP range, and connect the other end of USB cable to the instrument. (3) When your PC and the instrument are connected properly, the following figure appears. Select ”Locate and install driver software (recommended)”.
Page 2 (5) Select “I don’t have the disc. Show me other options”. (6) Select “Browse my computer for driver software(advanced)”.
Page 3 (7) Check the boxes for “Include subfolders”, and then click “Browse”. (8) Select a folder to download the file.
Page 4 (9) It's confirmed that a chosen folder is indicated, and click “Next”. (10) In case that following window appears on Windows Vista, click “Install this driver software anyway”. (It is an operation check, and no problem happens if install is continued.)
Page 5 (11) Install is completed when the wizard finishes. Click “Close”. (12) When installation above-mentioned ends, the following figure appears. Select “Don’t search online”. After that, step (5) to (11) will be repeated twice.
Page 6 (13) When 2 being installed as shown in the lower figure, a driver was normally installed. USB Driver Un-installation When install of the USB driver is interrupted and reinstall cannot be done, follow the procedure below and delete the existing driver, and then install it again.