Abus PLMK10000 Manual page 22

Note: Also keep the round magnet - it can be used for wake-up-command, removing
(exclusion) or reset the sensor.
Remove the protective film from the small adhesive
sticker of the sensor.
This allows the sensor to be easily moved before final
mounting.
Attach the sensor to the desired location and check
the position by carefully closing and fully opening the
window/door.
Check and determine where the square magnet
should be placed.
Then remove the protective film and place the
magnet. Open and close the window/door to see if
your Z-Wave Gateway detects the changes.
Reposition the sensor if necessary.
Once you have found the optimum position, mark it
and remove the sensor again.
Make sure that the area remains clean.
Remove the long protective film that protects the
Self-adhesive backside, and stick the sensor exactly
to the marked spot.
The long adhesive side is required to be used for the
final assembly.
Check whether the door or window can be completely
closed and opened and whether the Z-Wave
Gateway displays the status.
9
English