Advertisement
Quick Links
© Panduit Corp. 2016
FALLING EQUIPMENT HAZARD
Remove all equipment installed onto equipment rails before performing any adjustments to equipment rail spacing.
FAILURE TO FOLLOW THESE INSTRUCTIONS CAN LEAD TO SERIOUS INJURY, DEATH, OR DAMAGE TO YOUR EQUIPMENT.
Front Equipment Rail Installation
•
Remove existing front rails from cabinet posts (use T25 Torx bit to remove existing screws)
•
Install [2] Front Equipment Rails to Front Cabinet Posts with [5] Countersunk Torx screws per rail (use T25 Torx bit)
•
Use supplied shims (as necessary) to ensure proper EIA spacing of front equipment rails
REMOVE EXISITING
FRONT EQUIPMENT RAILS
(use T25 Torx bit)
Shim
(**use as necessary**)
INSTALLATION INSTRUCTIONS
Countersunk Torx Screw
(use T25 Torx bit)
[5] screws per rail
For Technical Support: www.panduit.com/resources/install_maintain.asp
N
-A
N-Type Switch Cabinets
ET
CCESS
(N2RCFR, N5RCFR, N8RCFR, N1RCFR Set of Four Cage Nut Equipment Rails)
(N2RTFR, N5RTFR, N8RTFR, N1RTFR Set of Four Tapped Equipment Rails)
WARNING
Page 1 of 3
Part numbers:
V00029CX
Advertisement
Related Manuals for Panduit N2RCFR
Summary of Contents for Panduit N2RCFR
- Page 1 N-Type Switch Cabinets CCESS Part numbers: (N2RCFR, N5RCFR, N8RCFR, N1RCFR Set of Four Cage Nut Equipment Rails) (N2RTFR, N5RTFR, N8RTFR, N1RTFR Set of Four Tapped Equipment Rails) INSTALLATION INSTRUCTIONS V00029CX © Panduit Corp. 2016 WARNING FALLING EQUIPMENT HAZARD Remove all equipment installed onto equipment rails before performing any adjustments to equipment rail spacing.
- Page 2 INSTALLATION INSTRUCTIONS V00029CX © Panduit Corp. 2016 Rear Equipment Rail Installation • Install [4] Equipment Rail Mounting Brackets to Equipment Rails with [3] Countersunk Torx screws per bracket (use T25 Torx bit) • Ensure that countersunk holes of brackets are oriented to match heads of countersunk screws...
- Page 3 INSTALLATION INSTRUCTIONS V00029CX © Panduit Corp. 2016 Rear Equipment Rail Installation • Locate desired Equipment Rail position • Insert [2] Equipment Rail Mount Nuts through slots of Front-to-Back Beam (top and bottom locations) • Fasten [2] M10 Hex Screws to E-Rail Mount Nuts at top and bottom of Equipment Rail •...