Configuring The Ethernet Interface; Troubleshooting; Resetting The Software - Bosch Access Modular Controller 2 Installation Manual

36 en | Operating
5.2

Configuring the Ethernet Interface

The access control system Access Personal Edition has an entry of this tool in its program
folder:
Start > Programs > Access Personal Edition > AmcIpConfig
This tool can be copied and used on every computer on the network.
5.3

Troubleshooting

If there is no indication on the display, check voltage provided from the power supply, power
up the controller.
If the controller is not online, or operation is not as expected per configuration:
1.
2.
3.
4.
If problem persists, please request after sales support.
5.3.1

Resetting the Software

Figure 5.2: Resetting the AMC2 16I-16O-NET
2020-01 | V02 |
Check connections/ configuration as per described in Chapter 4 and Section 5.2.
Cycle the power of the controller.
In rare cases reset the controller software as described in Section 5.3.1.
For factory default reset refer to Section 5.3.2.
Installation manual
Access Modular Controller 2
Bosch Access Systems B.V.