Advertisement
4.2.3. Using a suitable drill bit, drill on the centres marked and insert two of the enclosed wall plugs.
4.2.4. Insert two of the enclosed screws into the wall plugs, leaving the heads approximately 2mm proud of the wall.
4.2.5. Hang the heater by the upper keyhole shaped hole, allowing the bracket to sit with the screw at the top of the heyhole.
4.2.6. Check again for level; if correct, mark through the lower screw locations in the bottom brackets.
4.2.7. Remove the heater from the upper screws and drill suitable holes for the remaining wall plugs, then insert them.
4.2.8. Hang the heater again by the top brackets and secure by inserting and tightening the remaining screws through the two bottom brackets.
5.
OPERATION
5.1.
Plug the heater into the mains supply.
5.2.
Switch the on/off switch (fig.1) to the "I" position.
5.3.
Turn the thermostat control (fig.1) clockwise to its maximum position.
5.4.
When the desired air temperature has been reached, turn the thermostat control back until the thermostat is heard to click.
The heater will switch on and off automatically around this temperature.
5.5.
When the heater is not required to be working, return the on/off switch to the "O" position. If free standing; allow to cool down,unplug
from the mains supply and store in a safe, dry childproof place.
5.6.
The heater is fitted with an overheat thermostat. If this thermostat activates, switch the heater off and remove the plug from the mains
supply.
5.6.1. Investigate the reason for the overheat and remedy it.
5.6.2. When cool, reconnect to mains power and switch back on.
6.
MAINTENANCE
Before attempting any maintenance ensure the unit is unplugged from the mains power supply and that it is cool.
6.1.
Clean the unit with a soft dry cloth. DO NOT use abrasives or solvents.
6.2.
Check the air inlet and outlet periodically to ensure that the air way is clear.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to:
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Environmental Protection
www.sealey.co.uk, email: sales@sealey.co.uk or phone: 01284 757500.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
WEEE Regulations
01284 757500
01284 703534
www.sealey.co.uk
sales@sealey.co.uk
CD400 Issue: 1 - 09/12/14
Advertisement
