Cisco Catalyst 5000 Series Installation And Configuration Note page 3

Table 1 LED Descriptions (continued)
LED State
SYSTEM Red
STATUS
(continued)
Orange
Orange
FAN
Green
Red
PS1
Catalyst 5000, Catalyst 5505, Catalyst 5509, and Catalyst 5500 switches:
Green
Red
Off
Catalyst 5002 switch:
Green
Red
PS2
Catalyst 5000, Catalyst 5505, Catalyst 5509, and Catalyst 5500 switches:
Green
Red
Off
Catalyst 5002 switch:
Green
Red
SWITCH LOAD 1-100%
ACTIVE Green
Orange
100 Mbps Green
1000 Mbps Green
Catalyst 5000 Series Supervisor Engine III G Installation and Configuration Note
Description
During system boot or if the module is disabled.
The redundant power supply is installed but not turned on or receiving input.
The fan module fails.
Indicates the status of whether or not the fan is operational.
The fan is operational.
The fan is not operational.
Indicates the status of the power supply in the left bay.
The power supply in the left bay is operational.
The power supply in the left bay is not operational, switched off, or not
receiving input power.
The power supply in the left bay is off or not installed.
The Catalyst 5500 power supply LED is red when no modules are
Note
installed.
The power supply associated with the PS1 AC receptacle or DC terminal
block is operational.
The power supply associated with the PS1 AC receptacle or DC terminal
block is not receiving input power.
Indicates the status of the power supply in the right bay.
The power supply in the right bay is operational.
The power supply in the right bay is not operational, switched off, or not
receiving input power.
The power supply in the right bay is off or not installed.
The Catalyst 5500 power supply LED is red when no modules are
Note
installed.
The power supply associated with the PS2 AC receptacle or DC terminal
block is operational.
The power supply associated with the PS2 AC receptacle or DC terminal
block is not receiving input power.
If the switch is operational, the switch load display indicates (as an
approximate percentage) the current traffic load over the backplane (see
Figure 2).
The supervisor engine is operational and active.
The supervisor engine module is in standby mode.
The port is operating at 100 Mbps.
The port is operating at 1000 Mbps.
LEDs
3