Download Print this page

Installation - Bestway Fast Set 57265 Owner's Manual

Hide thumbs Also See for Fast Set 57265:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
NO.
Name
QTY
57289ASS17
57294ASS17
57294ASS17
57313ASS17
57313ASS17
57313ASS17
57313ASS17
57277ASS17
57277ASS17
57277ASS17
57319ASS17
01
Liner
1
57319ASS17
57319ASS17
57273ASS17
57273ASS17
57273ASS17
57266ASS17
57266ASS17
57266ASS17
57271ASS17
57271ASS17
57265ASS17
57265ASS17
57265ASS17
CHOOSE THE CORRECT LOCATION
NOTE: The pool must be set up on a completely flat and level surface. Please do not install
the pool if the surface is inclined or sloped.
Correct conditions to set up the pool:
• The selected location has to be capable of uniformly supporting the weight for the entire time the
pool is installed, moreover the location must be flat and must be cleared of all objects and debris
including stones and twigs.
• We recommend positioning the pool away from any objects children could use to climb into the pool.
NOTE: Position the pool near an adequate drainage system to deal with overflow or to discharge
the pool.
Incorrect conditions to set up the pool:
• On uneven ground the pool may collapse causing serious personal injury and/or damage to
personal property and will void the warranty and prevent any service claims.
• Sand should not be used to create a level base; the ground must be dug out if necessary.
• Directly under overhead power lines or trees. Be sure the location does not contain underground
utility pipes, lines or cables of any kind.
• Do not set up the pool on driveways, decks, platforms, gravel or asphalt surfaces. The selected
location should be firm enough to withstand the pressure of the water; Mud, sand, soft / loose soil
or tar are not suitable.
• Grass or other vegetation under the pool will die and may cause odors and slime to develop,
therefore we recommend removing all grass from the selected pool location.
• Avoid areas prone to aggressive plant and weed species that may grow through the ground cloth
or liner.
NOTE: Check with your local city council for by-laws relating to fencing, barriers, lighting and
safety requirements and ensure you comply with all laws.
NOTE: If have a filter pump, refer to the pump's manual for instructions.
NOTE: The ladder must match the pool size and should be used only for entering and exiting the
pool. It is forbidden to exceed the permitted payload of the ladder. Check regularly if the ladder is
properly assembled.

Installation

Bestway Inflatables will not be responsible for damage caused to the pool due to mishandling or
failure to follow these instructions.
ATTENTION: Do not use a high pressure air hose or over-inflate the top ring, it should be slightly
stiff to the touch.
NOTE: Do not use extension power cords to power your pump.
ATTENTION: Do not drag the pool on the ground, this can damage the pool.
NOTE: The base or bottom of the pool should be laid out properly (flat without wrinkles).
NOTE: Hot temperatures cause air to expand the ring and may cause damage. Leave some room
for expansion.
Please see FAQ's for additional information.
NOTE: Drawings for illustration purposes only.May not reflect actual product. Not to scale.
1
3
5
Part NO.
Remark
#57289
4.57m x 1.22m (15'x48")
4.57m x 1.07m (15'x42")
#57294
#57286
4.57m x 1.07m (15'x42")
#57318
4.57m x 84cm (15'x33")
#57316
4.57m x 84cm (15'x33")
#57315
4.57m x 84cm (15'x33")
#57313
4.57m x 84cm (15'x33")
#57277
3.66m x 91cm (12'x36")
#57263
3.66m x 91cm (12'x36")
#57278
3.66m x 91cm (12'x36")
#57323
3.96m x 84cm (13'x33")
#57321
3.96m x 84cm (13'x33")
#57319
3.96m x 84cm (13'x33")
#57275
3.66m x 76cm (12'x30")
#57274
3.66m x 76cm (12'x30")
#57273
3.66m x 76cm (12'x30")
#57270
3.05m x 76cm (10'x30")
3.05m x 76cm (10'x30")
#57269
#57266
3.05m x 76cm (10'x30")
#57272
2.74m x 76cm (9'x30")
#57271
2.74m x 76cm (9'x30")
#57268
2.44m x 66cm (8'x26")
#57267
2.44m x 66cm (8'x26")
#57265
2.44m x 66cm (8'x26")
2
4
6
ATTENTION: Do not leave pool unattended while filling with water.
Pool walls will rise as you fill with water.
1. Fill pool until water capacity is 80%, DO NOT OVERFILL as this could cause the pool to
collapse. In times of heavy rainfall you may need to empty some of the water to ensure the
level is correct.
2. When filling the pool is completed, check that the water is not collecting on any side to ensure
the pool is level.
IMPORTANT: If pool is not level, drain water and re-level ground by digging out. Never attempt
to move the pool with water in it, serious personal injury or damage to the pool may result.
WARNING: Your pool may contain a great deal of pressure. If your pool has any bulge or
uneven side, then the pool is not level, the sides may burst and the water may discharge
suddenly causing serious personal injury and/or damage to property.
POOL MAINTENANCE
Warning: If you do not adhere to the maintenance guidelines covered herein, your health might be
at risk, especially that of children. Pool water treatment is essential for the safety of the users.
Using chemicals inappropriately will cause property damage and personal injury.
NOTE: The pump is used to circulate the water and to filter small particles. In order to keep your
pool water clean and hygienic, you must also add chemicals.
1. It is recommended not to fill the pool with catchment water, drilling water, or drainage well
water: these waters generally contain polluted organic substances including nitrates and
phosphates. Filling pools with water from the public network is advised.
2. Always keep your pool clean and apply the correct pool chemicals. Unsanitary water is a
serious health hazard. It is recommended to use disinfectant, flocculant, acid or alkali chemicals
to treat your pool.
3. Clean the PVC liner regularly with non-abrasive brushes or a pool vacuum cleaner.
4. Throughout the season, the water filtration system must run long enough each day to clean the
entire volume of water in the pool.
5. Check the filter cartridge (or sand in a sand filter) regularly and replace dirty cartridges
(or sand).
6. Regularly check the screws, bolts and all the metal parts for rust. Replace if necessary.
7. If it rains, check that the water level is not higher than the specified level.
If water exceeds the specified levels, drain the pool to the specified level.
8. Do not use the pump when the pool is in use.
9. Cover the pool when not in use.
10. For pool water treatment, the pH value is very important.
ATTENTION: Do not leave the drained pool outside.
The following parameters ensure good quality water
Parameters
Water clarity
Colour of the water
Turbidity in FNU/NTU
Nitrate concentration above that of fill water in mg/l
Total organic carbon (TOC) in mg/l
Redox potential against Ag/AgCI 3,5 m KCl in mV
pH value
Free active chlorine (without cyanuric acid) in mg/l
Free chlorine used in combination with cyanuric
acid in mg/l
Cyanuric acid in mg/l
Combined chlorine in mg/l
Repair
Check pool for any leaks from valves or seams, check the ground cloth for any evident water loss.
Do not add chemicals until this has been done.
NOTE: In the event of a leak, patch your pool using the underwater adhesive repair patch provided.
Refer to the FAQs for further information.
Dismantling
1. Unscrew the drain valve cap counter-clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the hose in the area where you are
going to drain your pool. (Check local regulations for drainage by-laws).
3. Screw the control ring of the hose adaptor clockwise onto the drain valve. The drain valve will be
open and water will start to drain automatically. Open the drain valve to the maximum position.
4. Deflate the top ring by squeezing the air valve.
5. When the top ring is fully deflated, press the top ring down, and tilt it to drain the pool easily.
#05
Completely drain the water in the pool.
6. When draining is finished, unscrew the control ring to close the valve.
7. Disconnect the hose.
8. Screw the cap back onto the drain valve.
9. Air dry pool.
Storage and Winterization
1. Please remove all the accessories and spare parts of the pool and store them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to prevent pool from sticking together,
fold pool carefully. If pool is not completely dry, mold may result and will damage the pool liner.
3. Store liner and accessories in a dry place with a moderate temperature between 5ºC / 41ºF and
80%
38ºC / 100ºF.
4. During the rainy season, pool and accessories should be stored as per above instructions also.
5. Improper draining of the pool might cause serious personal injury and/or damage to personal
property.
6. We strongly recommend the pool is disassembled during the off season (winter months).
Store in a dry location out of children's reach.
4
4
Values
clear view of the pool bottom
no colour should be observed
max. 1,5 (preferably less than 0,5)
max. 20
max. 4,0
min. 650
6,8 to 7,6
0,3 to 1,5
1,0 to 3,0
max. 100
max. 0,5 (preferably close to 0,0 mg/l)
S-S-004333

Advertisement

loading