Technical Instructions; Product Specifications; Recommendations Before Installation - Bestway FLOWCLEAR 58677E Owner's Manual

Table of Contents

Advertisement

WARNING:
approved by the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.

TECHNICAL INSTRUCTIONS

• When working with electricity, turn the electrical power off at the circuit breaker and lock breaker door. Failure to do so will result in increased risk of
shock, injury and possibly death.
• DO NOT REMOVE THE GROUNDING PRONG OR MODIFY THE PLUG IN ANY WAY. DO NOT USE ADAPTOR PLUGS.
• Consult a qualified electrician for any questions related to the validity of your plugs grounding. Handle this product with care. Do not pull or carry
this product by the power cord. Never pull a plug from the outlet by yanking the power cord. Keep cord free from abrasions. Sharp objects, oil,
moving parts, and heat should never be exposed to this product.
• Examine equipment before use. Notify Bestway at the customer service address listed on this manual for any manufacturing defect or missing
parts at the time of purchase. Verify that the equipment components represent this product model that you had intended to purchase.
• Place this product on a solid and level ground. Pay attention to position of pool and this product, so adequate ventilation, drainage, and access for
cleaning is available.
• Never place this product in an area that may accumulate water, or in an area where foot traffic will flow around the pool.
• Atmospheric conditions may affect the performance and life span of this product.
• Unnecessary wear and tear may occur during periods of cold, heat and exposure to sun.
• Whenever possible shelter this product from these conditions. Assembly and disassembly of this product should only be performed by adults.
SETUP
CHECK LIST
To check the parts inside the manual. Verify that the equipment components represent the model that you had intended to purchase. In case of any
damaged or missing parts at the time of purchase, visit our website bestwayusa.com/support. Drawings are for illustration purposes only. May not
reflect actual product. Not to scale.

PRODUCT SPECIFICATIONS

Maximum chlorine production per hour:
Sand filter/Filter pump flow range:
Salt concentration:
Water temperature:
Ambient temperature:
Compatible with max water capacity:

RECOMMENDATIONS BEFORE INSTALLATION

• The chlorinator must be installed at the last position of the water circulation pipe (down the direction of the water flow) as shown in "1a, 1b, 1c and 1d".
• Only use sodium chloride (NaCl) salt with a purity of at least 99.8% to fully dissolve it.
• Too low salt content will reduce the efficiency of the chlorinator and result in low chlorine production. High salt content may produce a salty taste to
the pool water and it may cause corrosion to metal fixtures and fittings in the pool.
• The "Pool Salt Table" shows the correct amount of salt required. Refer to the different quantity of water. The salt in the pool will not automatically
decrease.
• Only when the pool water is lost will the salt in the water decrease, and the evaporation of water will not cause the salt to decrease.
Any changes or modifications to this unit not expressly
6 g/h
330-3000 gal/h
3000 ppm (3 g/L)
10-36°C
5-45°C
7000 gal (26495 L)
4

Advertisement

Table of Contents
loading

Table of Contents