Advertisement
Note:
Use the lower set of holes on each side
of the mounting plate when installing the plate.
3.
Torque the bolts to 92 to 113 N⋅m (68 to 82 ft-lb).
1. Mounting plate
2. Bolt (4)
6
Mounting the Debris Blower
to the Traction Unit
Parts needed for this procedure:
1
Debris-blower assembly
1
Locking pin
1
Hairpin cotter
Procedure
1.
Remove any attachment from the front of the
machine.
2.
Move the traction unit into position behind the
attachment adapter.
3.
Raise the traction unit adapter into the
attachment adapter.
Note:
If the jack stand is raised slightly higher
than the castors, the adapter is easier to install.
4.
Insert the locking pin through the adapters and
secure it with a hairpin cotter
Figure 6
3. Locknut (4)
(Figure
7).
g021677
1. Locking pin
5.
Install the drive shaft to the quick-attach frame
by sliding the quick coupler onto the shaft
(Figure
8).
1. Drive shaft
6.
Secure the safety chain to the quick-attach
frame
(Figure
6
Figure 7
2. Hairpin cotter
Figure 8
2. Quick-attach-frame shaft
8).
g023910
g021678
Advertisement
