Philips SP9863 Manual page 21

2
1
Using the beard styler attachment without comb
2 Slide the comb straight into the guiding grooves
on both sides of the beard styler attachment
('click').
3 Press the length selector and then push it to
the left or right to select the desired hair length
setting.
4 Switch on the appliance.
5 Move the appliance upwards while you exert
gentle pressure. Make sure the front of the
comb is in full contact with the skin.
6 Clean the attachment after use.
You can use the beard styler attachment without
the comb to contour your beard, moustache,
sideburns or neckline at a length of 0.5 mm
(1/32 in).
Note: The beard styler is only intended for
trimming facial hair. Do not use it on areas below
the neck.
1 Pull the comb off the beard styler attachment.
Note: Grab the comb in the center to pull it off
the beard styler attachment. Do not pull at the
sides of the comb.
2 Switch on the appliance.
21
English