Replacing The Filter; Removing The Filter; Technical Data - DeLonghi Dinamica Plus ECAM37X.95 Instructions For Use Manual

Please note
IThe filter lasts about two months if the appliance is used nor-
mally. If the coffee machine is left unused with the filter in-
stalled, it will last a maximum of 3 weeks.
5. "RUN WATER INTO FILTER HOLE" "UNTIL IT COMES OUT" (fig.
38): To activate the filter, run tap water through the hole
in the filter as shown in the figure until water comes out
of the openings at the side for more than a minute. Press
;
6. Extract the tank (A17) from the appliance and fill with
water.
7. "IMMERSE FILTER TO" "EXPEL AIR BUBBLES" (fig. 39): Insert
the filter in the water tank and immerse it completely for
about ten seconds, sloping it and pressing it lightly to ena-
ble the air bubbles to escape. Press
39
CONTAINER" "OK TO ENABLE FILTER" (fig. 7): Place the
container under the hot water spout (D6) and press
. Delivery begins and stops automatically.
The filter is now active and the coffee machine can be used.

16.2 Replacing the filter

Replace the filter (D7) when "REPLACE WATER FILTER" "PRESS
OK TO START" appears on the display: to replace immediately,
press and follow the instructions from point 5.
To replace the filter later, press
bol appears on the display to remind you that the filter needs
replacing. To replace, proceed as follows:
1. Extract the tank (A17) and exhausted filter;
2. Remove the new filter from the packaging;
3. Access the menu as described in section "6.1 Access the
settings menu";
4. Follow the operations described in the previous section
from point 3.
The filter is now active and the coffee machine can be used.
;
8. "INSERT FILTER"
HOUSING": Insert the fil-
ter (D7) in the filter hous-
ing (fig. 36) and press
as far as it will go. Press
;
9. "INSERT WATER TANK":
Close the tank with the
lid (A17), then put the
tank back in the machine
(fig. 5);
10. "POSITION 0.5L
. The sym-
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.

16.3 Removing the filter

If you want to use the appliance without the filter (D7), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Extract the tank (A17) and exhausted filter;
2. Access the menu as described in section "6.1 Access the
settings menu";
3. PRESS "WATER FILTER";
4. Press the selector corresponding to " REMOVE WATER
FILTER";
5. "CONFIRM FILTER REMOVAL": press
"IN
press
6. "FILTER REMOVED": the change has been saved. Press
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.

17. TECHNICAL DATA

Voltage:
Power:
Pressure:
Water tank capacity:
Size LxHxD:
Cord length:
Weight:
Beans container capacity:
Frequency:
Maximum transmission power
18
to go back to the settings menu);
to go back to the homepage.
220-240 V~ 50-60 Hz max. 10 A
1.9 MPa (19 bars)
240x440x360 mm
1750 mm
2400/2483.5 MHz
(or
1450 W
1.8 l
10 kg
300 g
10 mW