Wen GN9500 Instruction Manual page 24

CONNECTING ELECTRICAL DEVICES
CAUTION! Become familiar with the functions and capacity of each component on the control panel before
connecting electrical devices. Do not overload generator or individual panel receptacles. Do not connect 50Hz or
3-phase loads to the generator.
Follow the steps below to properly connect your device(s) to the generator:
1. Before connecting electrical devices, allow the generator to run for a few minutes to stabilize the speed and volt-
age output.
2. Select the device with the highest wattage, and make sure it is turned off. Plug the device into the matching gen-
erator outlet and then turn the device on. Allow the engine to stabilize.
3. Repeat step 2 to plug in each additional device. Do not attempt to plug in or start multiple devices at the same
time.
IN CASE OF OVERLOAD
If your generator becomes overloaded from too much drawn wattage, the push-to-reset circuit breaker(s) on your
control panel will activate and cut off the output. When an overload occurs, reduce the load by turning off and
unplugging your electronic device(s), then press the activated circuit breaker to reset your generator. If the circuit
breaker does not reset, wait several minutes and try again. If no power is produced after resetting, restart your
generator.
Key Pairing
Start
Remote
Pairing
Remote
Power
24
USING YOUR GENERATOR
12V DC
Light Outlet
DC Circuit
Breaker
5-20R Duplex
Circuit Breaker
AC 120V NEMA AC 120V NEMA
5-20V Duplex TT-30R RV
Multi-meter
AC Circuit
Breaker
AC 120V/240V
NEMA L-14-30R
Grounding
Nut